SMART EVO1 Mono , control panel for pumps

The evolution of the best electronic control panel SMART EVO 1 , control panel for pumps.
Ideal for booster sets or for drainage pumps on sewage water lifting stations.
The most complete control panel for sewage and pumping systems ever! Born from the need to combine in a single product the functions of Smart panels (for clean water: emptying, filling, pressurization, etc) and Drena panels (emptying and drainage sewage water) and to offer always more function, safety and control, SMART EVO raises the standard without axtra cost!
Technical features

Voltage 230 V 1∼

Power per pump 0.37-2.2 kW

Max current 18A

Single phase power supply 100-240Vac ±10% 50/60Hz (SMART EVO Mono);

G/P1 and G/P2 normally open inputs for start-up command;

3 inputs for single-pole level sensors (COM-MIN-MAX);

T1 and T2 inputs for motor clicson;

Normally open input for alarm activation;

AUTOMATIC-0-MANUAL buttons (spring return);

DIP-SWITCH selectors for: level alarm enable from sensors,

thermal cut-out activation delay 5/10 seconds,

alarm output settings,

alarm reset enable from motor clicson,

Filling/Emptying mode,

start/stop float enable,

enable of delay on board activation on power mains return,

Green led: power ON / failure or incorrect phase sequence;

Green leds: automatic mode enabled;

Green led: motor active;

Red led: level alarm from sensors or GA input;

Red leds: motor overload alarm/minimum current alarm;

Red leds: motor clicson activation alarm;

Electronic control of maximum current due to overload, with assisted calibration;

Electronic control of minimum current due to dry run, with assisted calibration;

Automatic reset due to minimum current alarm;

Protections of auxiliary circuits and motor with fuses;

Cumulative alarm output with voltage-free contacts (COM-NO-NC resistive load - 5A / 250V);

Cumulative alarm output, live (12Vcc / 100mA);

Door lock general disconnect switch;

Provision for start-up capacitors, single phase version (not included);

Box in ABS, IP55;

Ambient temperature: -5/+40 °C;

Relative humidity 50% at 40 °C (condensate free).