Well pump MULTI DIVER 1200 EVO

MULTI DIVER 1200 EVO
The electronically controlled MULTI DIVER 1200 EVO submersible pump is designed for drawing fresh, clean, cold water from vertebral wells, large-size tanks, as well as drilled deep water intakes of sufficient diameter (suggested pipe diameter 200mm). A well-thought pump design with an internal water cooling jacket, the engine to be cooled by the water being pumped.
Pumps of this design can be used where conventional submersible pumps would require the use of an additional motor cooling jacket.
The MULTI DIVER 1200 EVO operation control is carried out automatically by means of an electronic device controlling the pump's operation, by monitoring the rise and fall of the system pressure. The principle of control operation is simple, when the water intake starts, the pressure in the system drops, and the control device switches on the pump. The built-in flow sensor switches off the pump after a few seconds from the end of the water intake when the system pressure increases. When the pump is not working, the built-in non-return valve keeps the pressure in the discharge pipe and only when the water intake starts and the system pressure drops below 3.5 bar, the MULTI DIVER automatically switches on.
The pump is also equipped with an automatic dry run protection system. Detection by the control device of the lack of water flow in the installation will automatically shut down the pump, protecting it against damage caused by work without water. The range of hydraulic parameters of the pump and the ease of assembly allows it to be used for water supply of single-family houses, summer houses, irrigation of gardens and not very large agricultural areas.

Capasity max 105 l/min

H max 45 m, well h max 30m

Power 1,1kW, 1 x 230 V, 5 A

d 1"1/2

size:535 x 150 mm

cable 15m