Tuote 18/21
SMART EVO1 230 V 1∼vaihe, pumppukeskus

SMART EVO1 230 V 1∼vaihe, pumppukeskus

€199.00

Kuvaus

elektroninen ohjauspaneeli Elentek SMART EVO 1, ohjauspaneeli pumpulle. Ihanteellinen boosterille tai tyhjennyspumpulle jätevesiasemilla. Kattavin ohjauspaneeli jäteveden ja pumppausjärjestelmiin koskaan! Syntynyt tarpeesta yhdistää yhden tuotteen toimintoja Smart paneelit (puhdasta vettä: tyhjennys, täyttö, paineistus, jne) ja tyhjennyspaneelien (tyhjennys ja kuivatus jäteveden) ja tarjota aina enemmän toimintaa, turvallisuutta ja valvontaa, SMART EVO hoitaa kaikki!
Tuoteinfo
  • Voltage 230 V 1∼vaihe
  • Power per pump 0.37-2.2 kW
  • Max current 18A
  • Single phase power supply 100-240Vac ±10% 50/60Hz (SMART EVO Mono);
  • G/P1 and G/P2 normally open inputs for start-up command;
  • 3 inputs for single-pole level sensors (COM-MIN-MAX);
  • T1 and T2 inputs for motor clicson;
  • Normally open input for alarm activation;
  • AUTOMATIC-0-MANUAL buttons (spring return);
  • DIP-SWITCH selectors for: level alarm enable from sensors,
  • thermal cut-out activation delay 5/10 seconds,
  • alarm output settings,
  • alarm reset enable from motor clicson,
  • Filling/Emptying mode,
  • start/stop float enable,
  • enable of delay on board activation on power mains return,
  • Green led: power ON / failure or incorrect phase sequence;
  • Green leds: automatic mode enabled;
  • Green led: motor active;
  • Red led: level alarm from sensors or GA input;
  • Red leds: motor overload alarm/minimum current alarm;
  • Red leds: motor clicson activation alarm;
  • Electronic control of maximum current due to overload, with assisted calibration;
  • Electronic control of minimum current due to dry run, with assisted calibration;
  • Automatic reset due to minimum current alarm;
  • Protections of auxiliary circuits and motor with fuses;
  • Cumulative alarm output with voltage-free contacts (COM-NO-NC resistive load - 5A / 250V);
  • Cumulative alarm output, live (12Vcc / 100mA);
  • Door lock general disconnect switch;
  • Provision for start-up capacitors, single phase version (not included);
  • Box in ABS, IP55;
  • Ambient temperature: -5/+40 °C;
  • Relative humidity 50% at 40 °C (condensate free).
  • Ominaisuudet

    • Malli: 01015
    • Rahdituspaino: 8kg

    Arvostelut

    Ole ensimmäinen kirjoita arvostelu Kirjoita arvostelu.